德国罗德与施瓦茨R&S NRP-ZKU USB接口电缆
The code "NRP-ZKU" does not correspond to any specific meaning or definition. It is likely a random sequence of characters that does not have a commonly known or widely used interpretation.
型号: NRP-ZKU
USB Leistungsmesskopfkabel(1,50m), Für NRPxxS/T/A/SN/TN/AN Messkopfbetrieb am Laptop/PC, Stromversorgung über USB, Stecker: M12(sensorseitig) - USB A (Zubehör)
Definitions
Product data applies under the following conditions:
•
Three hours storage at the expected operating temperature followed by 30 minutes warm-up, unless otherwise stated
•
Specified environment
al conditions met
•
Recommended calibration interval adhered to
•
All internal automatic adjustments performed, if applicable
Specifications with limits
Describe warranted product performance by means of a range of val
ues for the specified parameter.
These specifications are mark
ed
with limiting symbols such as , ±,
or descriptions such as maximum and minimum.
Specifications in normal print refer to par
ameters where compliance is ensured by the
design or derived from the measurement of
related parameters.
Specifications in
bold
print are 100 % tested. Test limits have been narrowed by guard bands to take into account measurement
uncertainties, drift and aging, if applicable.
Specifications without limits
Describe warranted product performance by means of a representativ
e value for the specified param
eter. Limits are omitted whene
ver
they are not relevant for the spec
ification (e.g. dimensional data).
Typical values (typ.)
Represent the population mean for the given
parameter, derived from the design and/or
production testing. Typical values are no
t
warranted by Rohde & Schwarz.
Limits of uncertainty
Expanded uncertainties with a coverage factor of 2, calculated fr
om the test assembly specifications and the modeled behavior o
f the
sensor, including environmental c
onditions, aging, wear and tear, if applicable. T
he given values represent limits of uncertain
ty that are
met by the Rohde & Schwarz instrument after calibration at a prod
uction or service site. Limits of
uncertainty (in italics) are
defined in
EN 60359 and have been determined in line with the rules of the Guide to the Expression of Uncertainty in Measurement (GUM).
